This standard specifies the lifting operation classification, basic requirements of lifting safety management, safety inspection before lifting, safety measures during lifting, to-be-observed provisions of the operator, to-be-done works of the operator after lifting and management of Lifting Safety Operation Permit in chemical manufactory.
This standard is applicable to maintenance, repair and lifting operations in chemical manufactory.
2 Normative References
The following standards contain provisions which, through reference in this standard, constitute provisions of this standard. For dated references, subsequent amendments to (excluding corrections to) or revisions of, any of these publications do not apply to this standard. However, parties to agreements based on this standard are encouraged to investigate the possibility of applying the most recent editions of the normative documents indicated below. For undated references, the latest edition of the normative document referred to applies.
AQ 3021-2008, AQ/T 3021-2008, AQT 3021-2008, AQ3021-2008, AQ 3021, AQ3021, AQ/T3021-2008, AQ/T 3021, AQ/T3021, AQT3021-2008, AQT 3021, AQT3021
Introduction of AQ 3021-2008
1 Scope
This standard specifies the lifting operation classification, basic requirements of lifting safety management, safety inspection before lifting, safety measures during lifting, to-be-observed provisions of the operator, to-be-done works of the operator after lifting and management of Lifting Safety Operation Permit in chemical manufactory.
This standard is applicable to maintenance, repair and lifting operations in chemical manufactory.
2 Normative References
The following standards contain provisions which, through reference in this standard, constitute provisions of this standard. For dated references, subsequent amendments to (excluding corrections to) or revisions of, any of these publications do not apply to this standard. However, parties to agreements based on this standard are encouraged to investigate the possibility of applying the most recent editions of the normative documents indicated below. For undated references, the latest edition of the normative document referred to applies.
GB2811 Safety Helmet
GB5082 Commanding Signal for Lifting and Moving
GB 6067 Safety Rules for Lifting Appliances (GB/T 6067-1985 NF E52 122:1975, NEQ)
GB16179 Guidelines for the Use of Safety Signs
3 Terms and Definitions
For the purposes of this standard, the following terms and definitions apply.
Contents of AQ 3021-2008
Foreword i
1 Scope
2 Normative References
3 Terms and Definitions
4 Lifting Operation Classification
5 Basic Requirements of Lifting Safety Management
6 Safety Inspection before Lifting
7 Safety Measures during Lifting
8 To-be-observed Provisions of Operator
9 To-be-done Works of Operator after Lifting
10 Management of Lifting Safety Operation Permit
Annex A (Informative) Lifting Safety Operation Permit
