Detail of GB/T 30036-2013

Introduction of GB/T 30036-2013

Adaptive front-lighting system for motor vehicles 1 Scope This standard specifies the technical requirements, installation, test methods and inspection rules for adaptive front-lighting systems (hereinafter referred to as "AFS or the system") for motor vehicles. This standard is applicable to the adaptive front-lighting systems for categories M and N motor vehicles. 2 Normative references The following referenced documents are indispensable for the application of this document. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced documents (including any amendments) applies. GB 4599-2007 Motor vehicle headlamps equipped with filament lamps GB 4785-2007 Prescription for installation of the external lighting and light-signalling devices for motor vehicles and their trailers GB 15766.1 Lamps for road vehicles - Dimensional, electrical and luminous requirements GB 21259-2007 Headlamps equipped with gas-discharge light sources for motor vehicle GB 25991-2010 Automotive headlamps with LED light sources and/or LED modules ECE R37 Uniform provisions concerning the approval of filament lamps for use in approved lamp units on power-driven vehicles and of their trailers ECE R99 Uniform provisions concerning the approval of gas-discharge light sources for use in approved gas-discharge lamp units of power-driven vehicles 3 Terms and definitions For the purposes of this document, the terms and definitions given in GB 4599-2007, GB 4785-2007, GB 21259-2007 and GB 25991-2010 and the following apply. 3.1 adaptive front-lighting system; AFS a lighting device, providing beams with differing characteristics for automatic adaptation to varying conditions of use of the passing beam and the driving beam with a minimum functional content as specified in 5.3.1.1. Such systems consist of the "system control", one or more "supply and operating device(s)", if any, and the "installation units" of the right side and of the left side of the vehicle 3.2 class of a passing beam designation of a passing beam, identified according to the demands of lighting on different roads 3.2.1 class C of a passing beam basic passing beam 3.2.2 class V of a passing beam passing beam for use in lit areas such as towns 3.2.3 class E of a passing beam passing beam for use on roads such as expressways 3.2.4 class W of a passing beam passing beam for use in adverse conditions such as wet road 3.3 mode front-lighting function provided by a system, which means a beam within the range specified in 5.3.2 and 5.3.3, either for one of the passing beam classes or for the driving beam, designed and specified by the manufacturer for adaptation to dedicated vehicle and road conditions

Contents of GB/T 30036-2013

Foreword I 1 Scope 2 Normative references 3 Terms and definitions 4 Types of AFS systems 5 Requirements 6 Installation requirements 7 Test methods 8 Inspection rules Annex A (Normative) Testing of temperature stability and target luminous flux Annex B (Normative) Requirements for systems incorporating lenses of plastic material: testing of lens or material specimens and complete systems or part(s) of systems Annex C (Normative) Aiming requirements for cut-off line Annex D (Normative) Passing beam photometric requirements for AFS Annex E (Normative) Installation provisions on AFS system Annex F (Normative) Test procedure