This part of GB/T 7095 specifies the requirements of enamelled rectangular copper winding wire of class 130 with a sole coating based on polyethylene terephthalate resin.
The temperature in degrees Celsius corresponding to the temperature index is not necessarily that at which it is recommended that the wire be operated and this will depend on many factors, including the type of equipment involved.
The range of nominal conductor dimensions covered by this part is as follows:
- Width: minimum 2.00 mm; maximum 16.00 mm;
- Thickness: minimum 0.80 mm; maximum 5.60 mm.
Wires of grade 1 and grade 2 are included in this part and apply to the complete range of conductors.
The specified combinations of width and thickness as well as the specified ratio width/thickness are given in GB/T 7095.1-2008.
Foreword I 1 Scope 2 Normative References 3 Definitions and General Notes on Methods of Test and Appearance 4 Dimensions 5 Electrical Resistance 6 Elongation 7 Springiness 8 Flexibility and Adherence 9 Heat Shock 10 Cut-through 11 Resistance to Abrasion 12 Resistance to Solvents 13 Breakdown Voltage 14 Continuity of Insulation 15 Temperature Index 16 Resistance to Refrigerants 17 Solderability 18 Heat or Solvent Bonding 19 Dielectric Dissipation Factor 20 Resistance to Transformer Oil 21 Loss of Mass 23 Pin Hole Test 30 Packaging
This part of GB/T 7095 specifies the requirements of enamelled rectangular copper winding wire of class 130 with a sole coating based on polyethylene terephthalate resin.
The temperature in degrees Celsius corresponding to the temperature index is not necessarily that at which it is recommended that the wire be operated and this will depend on many factors, including the type of equipment involved.
The range of nominal conductor dimensions covered by this part is as follows:
- Width: minimum 2.00 mm; maximum 16.00 mm;
- Thickness: minimum 0.80 mm; maximum 5.60 mm.
Wires of grade 1 and grade 2 are included in this part and apply to the complete range of conductors.
The specified combinations of width and thickness as well as the specified ratio width/thickness are given in GB/T 7095.1-2008.
Contents of GB/T 7095.7-2008
Foreword I
1 Scope
2 Normative References
3 Definitions and General Notes on Methods of Test and Appearance
4 Dimensions
5 Electrical Resistance
6 Elongation
7 Springiness
8 Flexibility and Adherence
9 Heat Shock
10 Cut-through
11 Resistance to Abrasion
12 Resistance to Solvents
13 Breakdown Voltage
14 Continuity of Insulation
15 Temperature Index
16 Resistance to Refrigerants
17 Solderability
18 Heat or Solvent Bonding
19 Dielectric Dissipation Factor
20 Resistance to Transformer Oil
21 Loss of Mass
23 Pin Hole Test
30 Packaging
