Detail of YD/T 1583-2010

Introduction of YD/T 1583-2010

1 Scope This standard specifies the detailed requirements of Upper Layer (Layer 3) signaling architecture and primitives. This standard is applicable to 800MHz/2GHz cdma2000 digital cellular mobile communication network system. 2 Normative References The following normative document contains provisions which, through reference in this text, constitute provisions of this standard. For dated references, subsequent amendments to, or revisions of, any of these publications do not apply. However, parties to agreements based on this standard are encouraged to investigate the possibility of applying the most recent edition of the normative document indicated below. For undated references, the latest edition of the normative document referred to applies. ANISIJ-STD-018 Recommended Minimum Performance Requirements for 1.8 to 2.0 GHz Code Division Multiple Access (CDMA) Personal Stations TIA/EIA-98-C Recommended Minimum Performance Standards for Dual-Mode Spread Spectrum Mobile Stations, Date Pending TIA/EIA-553-A Core Analog Standard 800 MHz Mobile Station — Land Station Compatibility Specification with Authentication, Date Pending TIA/EIA-41-D Cellular Radiotelecommunications Intersystem Operations 3 Symbols and Abbreviation AC Authentication Center AUTHR Authentication Response AUTHBS Base Station Authentication Response BLOB Block of Bits CDMA Code Division Multiple Access CRC Cyclic Redundancy Code DTMF Dual-Tone Multifrequency ERP Effective Radiated Power ESN Electronic Serial Number f-csch Forward Common Signaling Logical Channel f-dsch Forward Dedicated Signaling Logical Channel GPS Global Positioning System HLR Home Location Register IMSI International Mobile Station Identity LSB Least Significant Bit MCC Mobile Country Code MCSB Message Control and Status Block MIN Mobile Identification Number MNC Mobile Network Code MSIN Mobile Station Identification Number MSB Most Significant Bit MSC Mobile Switching Center NMSI National Mobile Station Identity NDSS Network Directed System Selection NID Network Identification PACA Priority Access and Channel Assignment PCI Protocol Control Information PCS Personal Communications Services PDU Protocol Data Unit PN Pseudonoise PUF Power Up Function RC Radio Configuration RANDBS Base Station Random Variable SAP Service Access Point SDU Service Data Unit SSD Shared Secret Data SMS Short Message Services SID System Identification SCM Station Class Mark TMSI Temporary Mobile Station Identity 4 General 4.1 Signaling Architecture Layer 3 signaling for cdma2000 is modeled as follows: • Plane. Shared data plane (for signaling protocol) and control plane (used to monitor two planes of protocol, according to the functional requirements) • Protocol Layer. Layer 3 generates Layer 3 PDUs and passes these PDUs to Lower Layers, where proper encapsulation into Lower Layer PDUs is performed. On the receiving end, Lower Layer PDUs are decapsulated and the resulting SDUs are sent from Lower Layers to Layer 3 for processing. • Service Access Points. SAPs and corresponding communication primitives are defined between the Layer 3 and Lower Layers over the data plane. No SAPs are defined for communications through the control plane. 4.2 Signaling and Functionality 4.2.1 Control Plane and Data Plane

Contents of YD/T 1583-2010