This standard specifies general principles and requirements for the application of the single failure criterion to the electrical power, instrumentation and control portions of safety systems in nuclear power plant.
This standard interprets and provide guidance in the application of the single failure criterion, discuss failures, and present an acceptable method of single-failure analysis.
This standard not to identify where the single failure criterion is to be applied on any system.
This standard is applicable to safety systems in nuclear power plant.
This standard shall be used to establish conformance with the requirements of GB 13284.1-2008 and the single failure criterion as specified in that standard.
2 Normative References
The following normative documents contain provisions which, through reference in this text, constitute provisions of this standard. For dated references, subsequent amendments to, or revisions of, any of these publications do not apply. However, parties to agreements based on this standard are encouraged to investigate the possibility of applying the most recent editions of the normative documents indicated below. For undated references, the latest edition of the normative document referred to applies.
GB/T 7163 Requirements of Reliability Analysis for Nuclear Power Plant Safety Systems
GB/T 9225-1999 General Principles of Reliability Analysis for Nuclear Power Plant Safety Systems
GB/T 12788 Criteria for Class 1E Power Systems for Nuclear Power Generating Stations
GB/T 13284.1-2008 The Safety Systems for Nuclear Power Plants — Part 1: Design Criteria
GB/T 13286 Criteria for Independence of Class 1E Equipment and Circuits in Nuclear Power Plants
GB/T 13629 Applicable Criteria for Digital Computers in Safety Systems of Nuclear Power Plants
1 Scope
This standard specifies general principles and requirements for the application of the single failure criterion to the electrical power, instrumentation and control portions of safety systems in nuclear power plant.
This standard interprets and provide guidance in the application of the single failure criterion, discuss failures, and present an acceptable method of single-failure analysis.
This standard not to identify where the single failure criterion is to be applied on any system.
This standard is applicable to safety systems in nuclear power plant.
This standard shall be used to establish conformance with the requirements of GB 13284.1-2008 and the single failure criterion as specified in that standard.
2 Normative References
The following normative documents contain provisions which, through reference in this text, constitute provisions of this standard. For dated references, subsequent amendments to, or revisions of, any of these publications do not apply. However, parties to agreements based on this standard are encouraged to investigate the possibility of applying the most recent editions of the normative documents indicated below. For undated references, the latest edition of the normative document referred to applies.
GB/T 7163 Requirements of Reliability Analysis for Nuclear Power Plant Safety Systems
GB/T 9225-1999 General Principles of Reliability Analysis for Nuclear Power Plant Safety Systems
GB/T 12788 Criteria for Class 1E Power Systems for Nuclear Power Generating Stations
GB/T 13284.1-2008 The Safety Systems for Nuclear Power Plants — Part 1: Design Criteria
GB/T 13286 Criteria for Independence of Class 1E Equipment and Circuits in Nuclear Power Plants
GB/T 13629 Applicable Criteria for Digital Computers in Safety Systems of Nuclear Power Plants
3 Terms and Definitions
