1 Scope
This standard specifies the technical requirements, test methods, inspection rules and marking, packaging, transportation and storage of motor vehicles-window regulators.
This standard is applicable to window regulators used in motor vehicles, in the form of gear arm type, sheave type, and soft shaft type.
2 Normative references
The following normative documents contain provisions which, through reference in this text, constitute provisions of this standard. For dated references, subsequent amendments (excluding corrections) to, or revisions of, any of these publications do not apply. However, parties to agreements based on this standard are encouraged to investigate the possibility of applying the most recent editions of the standards indicated below. For undated references, the latest edition applies. QC/T 625-1999 Metallic coatings and conversion coatings for automobile
3 Terms and definitions
For the purpose of this standard, the following terms and definitions apply.
3.1
window regulator (hereinafter referred to as regulator)
device that raises or lowers the motor vehicle window along the window-oriented groove by a certain driving method and can stay at any position as required.
3.2
window oriented groove (hereinafter referred to as oriented groove)
component that guides the window when it moves up and down.
3.3
movement parallelity
distance difference between the two end points of the line (100mm long) and the corresponding end points before the movement when moving to a certain position, which is parallel to the OZ reference plane of the motor vehicle coordinate system on the window.
3.4
effective travel
part in the limit stroke of the regulator after subtracting 20mm from the upper and lower ends.
Foreword i
1 Scope
2 Normative references
3 Terms and definitions
4 Technical requirements
5 Test methods
6 Inspection rules
7 Marking, packaging, transportation and storage
Standard
QC/T 626-2008 Motor vehicles-window regulators (English Version)
1 Scope
This standard specifies the technical requirements, test methods, inspection rules and marking, packaging, transportation and storage of motor vehicles-window regulators.
This standard is applicable to window regulators used in motor vehicles, in the form of gear arm type, sheave type, and soft shaft type.
2 Normative references
The following normative documents contain provisions which, through reference in this text, constitute provisions of this standard. For dated references, subsequent amendments (excluding corrections) to, or revisions of, any of these publications do not apply. However, parties to agreements based on this standard are encouraged to investigate the possibility of applying the most recent editions of the standards indicated below. For undated references, the latest edition applies. QC/T 625-1999 Metallic coatings and conversion coatings for automobile
3 Terms and definitions
For the purpose of this standard, the following terms and definitions apply.
3.1
window regulator (hereinafter referred to as regulator)
device that raises or lowers the motor vehicle window along the window-oriented groove by a certain driving method and can stay at any position as required.
3.2
window oriented groove (hereinafter referred to as oriented groove)
component that guides the window when it moves up and down.
3.3
movement parallelity
distance difference between the two end points of the line (100mm long) and the corresponding end points before the movement when moving to a certain position, which is parallel to the OZ reference plane of the motor vehicle coordinate system on the window.
3.4
effective travel
part in the limit stroke of the regulator after subtracting 20mm from the upper and lower ends.
Contents of QC/T 626-2008
Foreword i
1 Scope
2 Normative references
3 Terms and definitions
4 Technical requirements
5 Test methods
6 Inspection rules
7 Marking, packaging, transportation and storage
