Detail of YD/T 1502-2006

Introduction of YD/T 1502-2006

1 Scope This standard specifies the service and functional testing methods for the multimedia message service terminal equipment of digital cellular mobile telecommunication network. It is applicable to terminals bearing multimedia message services in the digital cellular mobile telecommunication network in lower layer. 2 Normative References The following normative documents contain provisions which, through reference in this standard, constitute provisions of this standard. For dated reference, subsequent amendments to (excluding the correction contents), or revisions of do not applicable to this standard. However, parties to agreements based on this standard are encouraged to investigate the possibility of applying the most recent editions of these references indicated below. For undated references, the latest edition applies. [1] YD/T 1501-2006 Digital Cellular Mobile Telecommunication Network Specification for Multimedia Message Service Terminal Equipment 3 Terms, Definitions and Abbreviations For the purposes of this standard, the terms and definitions established in YD/T 1501-2006 Digital Cellular Mobile Telecommunication Network Specification for Multimedia Message Service Terminal Equipment and the following abbreviations apply. ... ... .... ... 4 Testing Environment 4.1 Testing Structure Testing structure is as shown in Figure 1. ...... ...... Notes: (1) The mobile network may be a GSM, GPRS, WCDMA, TD-SCDMA or cdma2000 network, which is determined according to the bearer mode supported by the MMS terminal under test. (2) According to the way that the mobile network is interconnected with the MMS central device, the gateway in the mobile network may be a WAP gateway or other gateway supporting the IMAP protocol. 4.2 Testing Equipment 4.2.1 Equipment under test ——Multimedia terminal Several

Contents of YD/T 1502-2006

Foreword i 1 Scope 2 Normative References 3 Terms, Definitions and Abbreviations 4 Testing Environment 4.1 Testing Structure 4.2 Testing Equipment 4.3 Precondition of Testing 5 General Testing Description 5.1 Testing Item Selection 5.2 Conformance Testing 5.3 Compatibility Testing 6 MMS Terminal Service Testing 6.1 Basic Service 6.2 Optional Services 7 Functional Testing 7.1 MM terminal Configuration 7.2 Support for MM Encapsulation Parameters 7.3 Support for MM Structure and Expression 7.4 Support for Media Contents 7.5 Support for Other Functions