1 Scope
This standard specifies terms and definitions, product classification, requirements, test methods, inspection rules, marking, packaging, transportation, storage, and instructions for use of bathroom furniture.
This standard is applicable to furniture used in toilet and bathroom, and may also serve as a reference for furniture used in other similar applications.
2 Normative references
The following normative documents contain provisions which, through reference in this standard, constitute provisions of this standard. For dated references, subsequent amendments (excluding corrections), or revisions, of any of these publications do not apply to this standard. However parties to agreements based on this standard are encouraged to investigate the possibility of applying the most recent editions of the normative documents indicated below. For undated references, the latest edition of the normative document referred to applies.
GB/T 1732 Determination of impact resistance of film
GB/T 2828.1-2003 Sampling procedures for inspection by attributes—Part 1: Sampling schemes indexed by acceptance quality limit (AQL) for lot-by-lot inspection
GB 4706.1-2005 Household and similar electrical appliances—Safety—Part 1: General requirements
GB/T 4893.1 Furniture—Assessment of surface resistance to cold liquids
GB/T 4893.2 Furniture—Assessment of surface resistance to wet heat
GB/T 4893.3 Furniture—Assessment of surface resistance to dry heat
GB/T 4893.4 Test of surface coatings of furniture—Determination of adhesion—Cross cut
GB/T 4893.7 Test of surface coatings of furniture—Determination of surface resistance to alternation of heat and cold
Foreword i
1 Scope
2 Normative references
3 Terms and definitions
4 Product classification
5 Requirements
6 Test methods
7 Inspection rules
8 Marking, packaging, transportation, storage and instructions for use
1 Scope
This standard specifies terms and definitions, product classification, requirements, test methods, inspection rules, marking, packaging, transportation, storage, and instructions for use of bathroom furniture.
This standard is applicable to furniture used in toilet and bathroom, and may also serve as a reference for furniture used in other similar applications.
2 Normative references
The following normative documents contain provisions which, through reference in this standard, constitute provisions of this standard. For dated references, subsequent amendments (excluding corrections), or revisions, of any of these publications do not apply to this standard. However parties to agreements based on this standard are encouraged to investigate the possibility of applying the most recent editions of the normative documents indicated below. For undated references, the latest edition of the normative document referred to applies.
GB/T 1732 Determination of impact resistance of film
GB/T 2828.1-2003 Sampling procedures for inspection by attributes—Part 1: Sampling schemes indexed by acceptance quality limit (AQL) for lot-by-lot inspection
GB 4706.1-2005 Household and similar electrical appliances—Safety—Part 1: General requirements
GB/T 4893.1 Furniture—Assessment of surface resistance to cold liquids
GB/T 4893.2 Furniture—Assessment of surface resistance to wet heat
GB/T 4893.3 Furniture—Assessment of surface resistance to dry heat
GB/T 4893.4 Test of surface coatings of furniture—Determination of adhesion—Cross cut
GB/T 4893.7 Test of surface coatings of furniture—Determination of surface resistance to alternation of heat and cold
Contents of GB 24977-2010
Foreword i
1 Scope
2 Normative references
3 Terms and definitions
4 Product classification
5 Requirements
6 Test methods
7 Inspection rules
8 Marking, packaging, transportation, storage and instructions for use
