Detail of QC/T 29106-2014

Introduction of QC/T 29106-2014

1 Scope This standard specifies the requirements, test methods, inspection rules, and marking, packaging, storage and preservation of automobile wire harness (hereinafter referred to as “wire harness”). This standard is applicable to a variety of automotive wire harnesses (including single wire components) with a nominal voltage below 60V. 2 Normative references The following referenced documents are indispensable for the application of this standard. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies. GB/T 2423.1-2008 Environmental testing - Part 2: Test methods - Tests A: Cold GB/T 2423.2-2008 Environmental testing for electric and electronic products - Part 2: Test methods - Test B: Dry heat GB/T 2423.17-2008 Environmental testing for electric and electronic products - Part 2: Test method - Test Ka: Salt mist GB/T 2423.22-2002 Environmental testing for electric and electronic products - Part 2: Test methods - Test N: Change of temperature GB/T 2828.1-2012 Sampling procedures for inspection by attributes - Part 1: Sampling schemes indexed by acceptance quality limit (AQL) for lot-by-lot inspection QB/T 4086 Glass cleaner GB 8410-2006 Flammability of automotive interior materials GB 11121 Gasoline engine oils GB 11122 Diesel engine oils GB/T 13527.2 Plasticized polyvinyl chloride tubing for electrical insulation GB 17930 Gasoline for motor vehicles GB 19147 Automobile diesel fuels (V) GB/T 25085 Road vehicles - 60V and 600V single-core cables GB/T 28046.3-2011 Road vehicles - Environmental conditions and testing for electrical and electronic equipment - Part 3: Mechanical loads QC/T 238 Storage and preservation for automotive parts QC/T 349 Plastic hoop QC/T 417.1-2001 Wire harness connector for vehicle - Part 1: Definition, test methods and general performance requirements (vehicle part) QC/T 417.3 Wire harness connector for vehicle - Part 3: Dimensions and special requirements of single-wire flat plug connectors QC/T 417.4 Wire harness connector for vehicle - Part 4: Dimensions and special requirements of multi-wire flat plug connectors QC/T 417.5 Wire harness connector for vehicle - Part 5: Dimensions and special requirements of cylindrical plug connectors for single- and multi-wire connectors QC/T 29010 Types, sizes and technical requirements of automobile low-voltage wire terminal QC/T 29013 Types, sizes and technical requirements of wire joints of automobile storage battery

Contents of QC/T 29106-2014

Foreword II 1 Scope 2 Normative references 3 Terms and definitions 4 Requirements 5 Test methods 6 Inspection rules 7 Marking, packaging, storage and preservation Annex A (Normative) Requirements for the cross section at the crimping point of terminal and wire conductor and the crimping juncture Annex B (Normative) Double-wall heat-shrinkable tubes for automobile wire harness Annex C (Normative) Pressure-sensitive adhesive tapes for automobile wire harness Annex D (Normative) Bellows for automobile wire harness