1 Scope
This standard specifies the method of thermal performance test (including type approval test, acceptance test, arbitration test and operation test) of steam boiler and hot-water boiler with working pressure less than 3.8MPa; it also specifies that the test result is expressed in table form.
This standard is applicable to boilers manually or mechanically combusting solid fuel, those combusting liquid or gas fuels or those adopting electricity as thermal energy. It may be applicable to hot oil carrier boiler or that adopting garbage as fuel for reference. This standard is not applicable to heat recovery boiler.
2 Normative References
The following normative documents contain provisions which, through reference in this text, constitute provisions of this standard. For dated references, subsequent amendments to (excluding amending errors in the text), or revisions of, any of these publications do not apply. However, all parties coming to an agreement according to this standard are encouraged to study whether the latest edition of the normative document is applicable. For undated references, the latest edition of the normative document applies.
GB/T 474-1996 Method for Preparation of Coal Sample (eqv ISO 1988:1975)
GB/T 2900.48-1983 Electrotechnical Terminology - Stationary Boilers
3 Terms and Definitions
For the purposes of this standard, the terms and definitions specified in GB/T 2900.48-1983 and those listed below apply.
3.1
Solid fuel
Any fuel in the solid state, including coal, oil shale, bagasse, firewood and solid wastes.
3.2
Liquid fuel
Any fuel in liquid state, including fuel oil and industrial liquid wastes (e.g. alkali liquor, magnesium liquor, etc.).
3.3
Gas fuel
Any fuel in gas state, including natural gas, blast furnace gas, coke oven gas, city gas, liquefied gas, etc.
3.4
Gross calorific value
Foreword I
1 Scope
2 Normative References
3 Terms and Definitions
4 Symbols and Units
5 General
6 Test Preparation
7 Test Requirements
8 Measurement Items
9 Test Method
10 Calculation of Boiler Efficiency
11 Calculation of Others
12 Test Report
Appendix A (Normative) Sampling and Preparation of Coal and Pulverized Coal
Appendix B (Normative) Preparation Method for Absorbent of Orsat Gas Analyzer
Appendix C (Normative) Determination Method for Humidity of Saturated Steam and Salt Content of Superheated Steam
Appendix D (Normative) Heat Radiation Loss
Appendix E (Informative) Average Specific Heat at Constant Pressure of Smoke, Ash and Air
Appendix F (Informative) Relevant Quantity Values of Common Gases
1 Scope
This standard specifies the method of thermal performance test (including type approval test, acceptance test, arbitration test and operation test) of steam boiler and hot-water boiler with working pressure less than 3.8MPa; it also specifies that the test result is expressed in table form.
This standard is applicable to boilers manually or mechanically combusting solid fuel, those combusting liquid or gas fuels or those adopting electricity as thermal energy. It may be applicable to hot oil carrier boiler or that adopting garbage as fuel for reference. This standard is not applicable to heat recovery boiler.
2 Normative References
The following normative documents contain provisions which, through reference in this text, constitute provisions of this standard. For dated references, subsequent amendments to (excluding amending errors in the text), or revisions of, any of these publications do not apply. However, all parties coming to an agreement according to this standard are encouraged to study whether the latest edition of the normative document is applicable. For undated references, the latest edition of the normative document applies.
GB/T 474-1996 Method for Preparation of Coal Sample (eqv ISO 1988:1975)
GB/T 2900.48-1983 Electrotechnical Terminology - Stationary Boilers
3 Terms and Definitions
For the purposes of this standard, the terms and definitions specified in GB/T 2900.48-1983 and those listed below apply.
3.1
Solid fuel
Any fuel in the solid state, including coal, oil shale, bagasse, firewood and solid wastes.
3.2
Liquid fuel
Any fuel in liquid state, including fuel oil and industrial liquid wastes (e.g. alkali liquor, magnesium liquor, etc.).
3.3
Gas fuel
Any fuel in gas state, including natural gas, blast furnace gas, coke oven gas, city gas, liquefied gas, etc.
3.4
Gross calorific value
Contents of GB/T 10180-2003
Foreword I
1 Scope
2 Normative References
3 Terms and Definitions
4 Symbols and Units
5 General
6 Test Preparation
7 Test Requirements
8 Measurement Items
9 Test Method
10 Calculation of Boiler Efficiency
11 Calculation of Others
12 Test Report
Appendix A (Normative) Sampling and Preparation of Coal and Pulverized Coal
Appendix B (Normative) Preparation Method for Absorbent of Orsat Gas Analyzer
Appendix C (Normative) Determination Method for Humidity of Saturated Steam and Salt Content of Superheated Steam
Appendix D (Normative) Heat Radiation Loss
Appendix E (Informative) Average Specific Heat at Constant Pressure of Smoke, Ash and Air
Appendix F (Informative) Relevant Quantity Values of Common Gases
