1 Scope
This Standard specifies the basic dimensions, design function and strength requirements of corner fittings for various freight containers which conform to GB/T 1413, GB/T 5338, GB/T 7392 and GB/T 16563, as well as the types, materials and general principles of test, inspection, marking and packaging of corner fittings for freight containers.
This Standard is applicable to the various freight containers which conform to GB/T 1413, GB/T 5338, GB/T 7392 and GB/T 16563.
This Standard is not applicable to the air / surface (intermodal) freight containers specified in GB/T 17770.
2 Normative References
The following standards contain provisions which, through reference in this text, constitute provisions of this standard. For dated reference, subsequent amendments to (excluding correction to), or revisions of, any of these publications do not apply. However, the parties to agreements based on this standard are encouraged to investigate the possibility of applying the most recent editions of the standards. For undated references, the latest edition of the normative document referred to applies.
Contents
Foreword i
Introduction iii
1 Scope
2 Normative References
3 Dimensional Requirements
4 Strength Requirements
5 Design Requirements
6 Minimum Bearing Area - Top Corner Fitting
7 Corner Fitting Marking (If Any)
8 Requirements for the Fixtures on the Freight Container Cars
9 Other Requirements
Annex A (Informative) Examples of Overall Dimensions of Box-Shaped Corner Fittings
Annex B (Informative) Typical Examples of Twistlock Lifting Devices
Annex C (Informative) Positions and Dimensional Requirements of Twistlock Tie-Down Devices on Freight Container Cars
Annex D (Normative) Types, Requirements, Inspection, Marking and Packaging of Corner Fittings for Freight Containers
Bibliography
1 Scope
This Standard specifies the basic dimensions, design function and strength requirements of corner fittings for various freight containers which conform to GB/T 1413, GB/T 5338, GB/T 7392 and GB/T 16563, as well as the types, materials and general principles of test, inspection, marking and packaging of corner fittings for freight containers.
This Standard is applicable to the various freight containers which conform to GB/T 1413, GB/T 5338, GB/T 7392 and GB/T 16563.
This Standard is not applicable to the air / surface (intermodal) freight containers specified in GB/T 17770.
2 Normative References
The following standards contain provisions which, through reference in this text, constitute provisions of this standard. For dated reference, subsequent amendments to (excluding correction to), or revisions of, any of these publications do not apply. However, the parties to agreements based on this standard are encouraged to investigate the possibility of applying the most recent editions of the standards. For undated references, the latest edition of the normative document referred to applies.
Contents of GB/T 1835-2006
Contents
Foreword i
Introduction iii
1 Scope
2 Normative References
3 Dimensional Requirements
4 Strength Requirements
5 Design Requirements
6 Minimum Bearing Area - Top Corner Fitting
7 Corner Fitting Marking (If Any)
8 Requirements for the Fixtures on the Freight Container Cars
9 Other Requirements
Annex A (Informative) Examples of Overall Dimensions of Box-Shaped Corner Fittings
Annex B (Informative) Typical Examples of Twistlock Lifting Devices
Annex C (Informative) Positions and Dimensional Requirements of Twistlock Tie-Down Devices on Freight Container Cars
Annex D (Normative) Types, Requirements, Inspection, Marking and Packaging of Corner Fittings for Freight Containers
Bibliography
