This Standard specifies the product classification, specification & model, requirements, test methods, inspection rules as well as marking, packaging, transportation and storage of the stainless steel corrugated tubes for the connection of gas appliances (hereinafter referred to as "the tube").
This Standard is applicable to the tube for the connection between the gas cooking appliances, gas water heater and gas meter etc., with the nominal dimension DN less than or equal to N32 and nominal pressure less than or equal to 0.01MPa, which are installed in a fixed way, and the gas pipeline.
Foreword I 1 Scope 2 Normative References 3 Terms and Definitions 4 Product Classification, Specification & Model 5 Special Requirements for Material and Machining Process 6 Requirements 7 Test Method 8 Inspection Rules 9 Marking, Packaging, Transportation and Storage Appendix A (Informative) Comparison of Structural Differences between This Standard and JIS S2145- Appendix B (Informative) Special Requirements for Machining Process Bibliography
CJ/T 197-2010, CJ 197-2010, CJT 197-2010, CJ/T197-2010, CJ/T 197, CJ/T197, CJ197-2010, CJ 197, CJ197, CJT197-2010, CJT 197, CJT197
Introduction of CJ/T 197-2010
本标准规定了燃气用具连接用不锈钢波纹软管的产品分类、规格及型号编制、要求、试验方法、检验规则、标志、包装、运输和贮存。
本标准适用于公称尺寸DN≤N32,公称压力PN≤0.01MPA固定安装的燃气灶具、燃气热水器和燃气表等与燃气管道连接用软管。
This Standard specifies the product classification, specification & model, requirements, test methods, inspection rules as well as marking, packaging, transportation and storage of the stainless steel corrugated tubes for the connection of gas appliances (hereinafter referred to as "the tube").
This Standard is applicable to the tube for the connection between the gas cooking appliances, gas water heater and gas meter etc., with the nominal dimension DN less than or equal to N32 and nominal pressure less than or equal to 0.01MPa, which are installed in a fixed way, and the gas pipeline.
Contents of CJ/T 197-2010
Foreword I
1 Scope
2 Normative References
3 Terms and Definitions
4 Product Classification, Specification & Model
5 Special Requirements for Material and Machining Process
6 Requirements
7 Test Method
8 Inspection Rules
9 Marking, Packaging, Transportation and Storage
Appendix A (Informative) Comparison of Structural Differences between This Standard and JIS S2145-
Appendix B (Informative) Special Requirements for Machining Process
Bibliography
