1.0.1 This standard is formulated with a view to following out the relevant national laws and regulations; pre-controlling, controlling and improving the soil erosion caused by development and construction activities; relieving possible negative influence on the ecological environment; and preventing soil erosion hazards.
1.0.2 This standard is applicable to soil erosion control for development and construction projects that may cause soil erosion during construction or manufacturing process.
1.0.3 In the soil erosion control of development and construction projects, the investigation shall be valued, it is encouraged to adopt new technique, process, and material, which make the engineering be featured in adaptation to local conditions, integrated control quality, practicality and esthetic appearance.
1.0.4 The design for soil and water conservation engineering shall, besides meeting the requirements this standard, comply with the requirements in the current relevant standards of the nation.
1 General Provisions
2 Terms
3 Basic requirements
3.1 General Requirements
3.2 Restrictive requirements of principal part of the project
3.3 Special requirements on different soil erosion area
3.4 Special requirements in construction projects of different type
4 Tasks at design stages
4.1 Basic requirements
4.2 Primary missions
5 Water and soil conservation scheme
5.1 General Requirements
5.2 General requirements in investigations and exploration survey
5.3 Basic requirements in general introduction
5.4 Basic requirements in general introduction of the project area
5.5 Analysis and evaluation on water and soil conservation of the principal part of the project
5.6 The range of responsibility for soil erosion control and control zoning
5.7 Basic requirements in soil erosion prediction
5.8 Arrangement of soil erosion control measures
5.9 Basic requirements in water and soil conservation monitoring
5.10 Requirements in implementing safeguard measures
5.11 Conclusion and suggestion
5.12 Requirements in main content of the water and soil conservation scheme
6 Special chapter on preliminary design of water and soil conservation
6.1 General Requirements
6.2 Requirements of the main content of special chapter on water and soil conservation
7 Residue retaining engineering
7.1 General Requirements
7.2 Applicable conditions
7.3 Design requirements
8 Slope protection engineering
8.1 General Requirements
8.2 Applicable conditions
8.3 Design requirements
9 Land consolidation and improvement
9.1 General provisions
9.2 Applicable conditions
9.3 Design requirements
10 The flood control and drainage engineering
10.1 General provisions
10.2 Applicable conditions
10.3 Design requirements
11 Dewatering and water storage & seepage engineering
11.1 General Provisions
11.2 Applicable conditions
11.3 Design requirements
12 Temporary protection engineering
12.1 General Provisions
12.2 Applicable conditions
12.3 Design requirements
13 Vegetation cover construction engineering
13.2 Service conditions
13.3 Design requirements
14 Wind-breaking and sand-fixing engineering
14.1 General provisions
14.2 Applicable conditions
14.3 Design requirements
Annex A: Requirements in the Content of the Water and Soil Conservation Scheme
Annex B: Requirements in the Content of the Water and Soil Conservation Scheme Report Table
1.0.1 This standard is formulated with a view to following out the relevant national laws and regulations; pre-controlling, controlling and improving the soil erosion caused by development and construction activities; relieving possible negative influence on the ecological environment; and preventing soil erosion hazards.
1.0.2 This standard is applicable to soil erosion control for development and construction projects that may cause soil erosion during construction or manufacturing process.
1.0.3 In the soil erosion control of development and construction projects, the investigation shall be valued, it is encouraged to adopt new technique, process, and material, which make the engineering be featured in adaptation to local conditions, integrated control quality, practicality and esthetic appearance.
1.0.4 The design for soil and water conservation engineering shall, besides meeting the requirements this standard, comply with the requirements in the current relevant standards of the nation.
Contents of GB 50433-2008
1 General Provisions
2 Terms
3 Basic requirements
3.1 General Requirements
3.2 Restrictive requirements of principal part of the project
3.3 Special requirements on different soil erosion area
3.4 Special requirements in construction projects of different type
4 Tasks at design stages
4.1 Basic requirements
4.2 Primary missions
5 Water and soil conservation scheme
5.1 General Requirements
5.2 General requirements in investigations and exploration survey
5.3 Basic requirements in general introduction
5.4 Basic requirements in general introduction of the project area
5.5 Analysis and evaluation on water and soil conservation of the principal part of the project
5.6 The range of responsibility for soil erosion control and control zoning
5.7 Basic requirements in soil erosion prediction
5.8 Arrangement of soil erosion control measures
5.9 Basic requirements in water and soil conservation monitoring
5.10 Requirements in implementing safeguard measures
5.11 Conclusion and suggestion
5.12 Requirements in main content of the water and soil conservation scheme
6 Special chapter on preliminary design of water and soil conservation
6.1 General Requirements
6.2 Requirements of the main content of special chapter on water and soil conservation
7 Residue retaining engineering
7.1 General Requirements
7.2 Applicable conditions
7.3 Design requirements
8 Slope protection engineering
8.1 General Requirements
8.2 Applicable conditions
8.3 Design requirements
9 Land consolidation and improvement
9.1 General provisions
9.2 Applicable conditions
9.3 Design requirements
10 The flood control and drainage engineering
10.1 General provisions
10.2 Applicable conditions
10.3 Design requirements
11 Dewatering and water storage & seepage engineering
11.1 General Provisions
11.2 Applicable conditions
11.3 Design requirements
12 Temporary protection engineering
12.1 General Provisions
12.2 Applicable conditions
12.3 Design requirements
13 Vegetation cover construction engineering
13.2 Service conditions
13.3 Design requirements
14 Wind-breaking and sand-fixing engineering
14.1 General provisions
14.2 Applicable conditions
14.3 Design requirements
Annex A: Requirements in the Content of the Water and Soil Conservation Scheme
Annex B: Requirements in the Content of the Water and Soil Conservation Scheme Report Table
