Detail of GB 51093-2015

Introduction of GB 51093-2015

1 General Provisions 1.0.1 This code is formulated with a view to improving the technology level for hydrochloric acid regeneration engineering with spraying and roasting method of iron and steel enterprises, guaranteeing the engineering quality and achieving advanced technology, economic rationality and environmental protection. 1.0.2 This code is applicable to the construction, operation and maintenance management of newly-built and renovated hydrochloric acid regeneration engineering with spraying and roasting technology of steel and iron enterprises 1.0.3 Apart from the requirements specified in this code, the construction of hydrochloric acid regeneration engineering with spraying and roasting technology of steel and iron enterprises shall also meet the requirements of relevant current national standards. 2 Terms 2.0.1 Hydrochloric acid regeneration process The process that the hydrochloric acid waste generated from the treatment of pickling line was re-generated through a series of chemical reactions to be re-used for pickling line. 2.0.2 Spraying and roasting technology The acid and ferric oxide regeneration technology by spraying waste hydrochloric acid in the roasting furnace to have chemical reaction under high-temperature environment. 2.0.3 Tank farm The area for storing the tanks of fresh acid, waste acid, regenerated acid, rinse water and other liquid. 2.0.4 Waste acid The waste hydrochloric acid from pickling line. 2.0.5 Regenerated acid The hydrochloric acid generated from the hydrochloric acid regeneration unit and reused for pickling line. 2.0.6 Fresh acid The purchased hydrochloric acid product. 2.0.7 Rinse water The discharge water after cleaning the strip steel of pickling line at the rinsing technology section. 2.0.8 Ferric oxide The ferric oxide powder generated from the spraying and roasting technology. 2.0.9 Concentrated acid The waste acid undergoing heat exchange of preconcentrator and circulatory concentration. 2.0.10 Roaster The equipment in which the sprayed concentrated acid is vaporized and subjected to chemical reaction under high-temperature environment to generate hydrochloric acid gas and ferric oxide. 2.0.11 Spray boom The equipment which sprays in the concentrated acid from the top of roaster. 2.0.12 Cyclone separator The equipment installed between the roaster and the preconcentrator for separating the ferric oxide from flue gas. 2.0.13 Preconcentrator The equipment for cooling and dedusting the flue gas of roaster and concentrating the waste acid.

Contents of GB 51093-2015

1 General Provisions 2 Terms 3 Basic Requirements 4 Process Design 4.1 Process Parameters 4.2 Configurations 4.3 Process Arrangement 5 Process Equipment and Piping 5.1 General Regulations 5.2 Equipment 5.3 Piping 5.4 Insulation 6 Electrical Automation 6.1 Low Voltage Distribution 6.2 Electrical Drive 6.3 Process Detection and Control Instruments 6.4 Basic Automation System 6.5 Telecommunication Facilities 7 Plant Design 7.1 General Requirements 7.2 Master Plan 7.3 Water Supply and Drainage Facilities 7.4 Combustion Gas Facilities 7.5 Heating Facilities 7.6 Ventilation Facilities 7.7 Laboratory Facilities 7.8 Architecture and Structure 7.9 Anti-corrosion Design 8 Construction and Installation 8.1 General Requirements 8.2 Civil Construction 8.3 Equipment Installation 8.4 Brick Lining Construction 8.5 Piping Installation 9 Commissioning and Assessment 9.1 General Requirements 9.2 Commissioning 9.3 Assessment 10 Operation and Maintenance 11 Energy Conservation and Environment Protection 12 Safety and Fire Extinguish Explanation of Wording in the Code List of Quoted Standards 1 Gen